 |
| After running yesterday we had noticed the rear pin on the lubricator linkage had worked itself loose and come off somewhere down the line, so a new pin was required |
 |
| Showing where the pin should be |
 |
| Meanwhile Joe carries out some painting at the front end |
 |
| Suitable piece sourced and placed in the lathe |
 |
| Machining the new pin |
 |
| Parting it off |
 |
| Success... |
 |
| ...drilling a hole for the split pin |
 |
| And finally fitting the pin and linkage |
No comments:
Post a Comment